NETGEAR WNDR4000 Network Router User Manual


 
20 | Chapter 2. Set Up Your Internet Connection
N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual
Note: The Setup Wizard cannot detect a Point-to-Point Tunneling Protocol
(PPTP) connection. If your ISP uses PPTP, you have to set your
Internet connection through the screen described in
Manual Setup
(Basic Settings) on page 20.
Manual Setup (Basic Settings)
The Basic Settings screen displays when you select No. I want to configure the router myself
in the Setup Wizard and is also available from the wireless router menu. It is where you view
or change ISP information. The fields that display vary depending on whether or not your
Internet connection requires a login.
Note: Check that the country is set as described Setup Wizard on page 19
before proceeding with the manual setup.
1. Select Set Up > Basic Settings, and select Yes or No depending on whether or not
your ISP requires a login.
Figure 2, Basic Settings screen without (left) and with (right)
login shows both forms of the Basic Settings screen.
Yes. Select the encapsulation method and enter the login name. If you want to
change the login time-out, enter a new value in minutes.
No. Enter the account and domain names, as needed.
2. Enter the settings for the IP address and DNS server. The default DSL settings usually work
fine. If you have problems with your connection, check the DSL settings, and see
Unsuccessful Internet Connection on page 23 for more information.
3. If no login is required, you can specify the MAC Address setting.
4. Click Apply to save your settings.