Filter
Top Products
3-22 Command Line Interface Commands Reference
cp { name | index } ip state-insp xposed-list xposed-list_name
no cp { name | index } ip state-insp xposed-list
show cp { name | index } ip state-insp xposed-list
These commands allow you to set, disable, or show the status of a stateful inspection exposed address list for
the specified Connection Profile. Exposed address lists are similar to NAT server lists. Exposed addresses in
the list will not be subject to stateful inspection and hence unsolicited inbound traffic will be allowed to these
addresses.
These are active only if NAT is disabled on the profile.
cp { name | index } ip state-insp tcp-seq-diff diff
show cp { name | index } ip state-insp tcp-seq-diff
These commands allow you to set or show TCP sequence difference acceptable for the specified Connection
Profile.
cp { name | index } ip state-insp router-access { yes | no | on | off }
no cp { name | index } ip state-insp router-access
show cp { name | index } ip state-insp router-access
These commands allow you to set, disable, or show the status of default mapping to router for the specified
Connection Profile.
cp { name | index } ip state-insp deny-frag { yes | no | on | off }
no cp { name | index } ip state-insp deny-frag
show cp { name | index } ip state-insp deny-frag
These commands allow you to set, disable, or show whether fragmented packets are received for the specified
Connection Profile.
L2TP Connection Profile Configuration Commands
Note: The commands in this section are supported beginning with Firmware Version 8.2.
cp { name | index } l2tp ip partner ip-addr
show cp { name | index } l2tp ip partner
These commands allow you to specify or show the partner Ipv4 address associated with the local L2TP tunnel.
cp { name | index } l2tp ip via ip-addr
show cp { name | index } l2tp ip via
These commands allow you to specify or show a gateway address at which the partner address may be reached
when the partner IP and the remote IP addresses are on the same subnet.
cp { name | index } l2tp authentication enable { yes | no }
show cp { name | index } l2tp authentication enable
These commands allow you to enable, disable or show the status of L2TP CHAP-like tunnel authentication for
the specified profile.