Filter
Top Products
Motorola Netopia® Router CLI Commands 2-9
snmp heartbeat-interval interval
show snmp heartbeat-interval
no snmp heartbeat-interval
Note: These commands are supported beginning with firmware version 8.2.
These commands allow you to set, show, or delete the SNMP heartbeat interval. A single configuration item
governs heartbeat traps, the time interval between traps. Permitted values are 0 – 65535 minutes. A value of
zero, the default, means the trap is disabled. This value can be configured by the CLI and SNMP. When the
interval value is set to a positive number, a trap is sent immediately and the new (or same) interval value takes
effect.
snmp notify type [ v1-trap | v2-trap | inform ]
Note: This command is supported beginning with firmware version 8.4.2.
This command allows you to set the type of SNMP traps that the system will generate: v1, v2(c), or, beginning
with Firmware Version 8.4.2, inform.
snmp system contact string
show snmp system contact
no snmp system contact
These commands set, display, or clear the router's SNMP system contact (sysContact) string.
snmp system location string
show snmp system location
no snmp system location
These commands set, display, or clear the router's SNMP system location (sysLocation) string.
snmp system name string
show snmp system name
no snmp system name
These commands set, display, or clear the router's SNMP system name (sysName) string.
snmp system trap source address [ lan | wan ]
Note: This command is supported beginning with firmware version 8.5.
This command allows you to specify whether the source address for SNMP traps should be on the LAN or the
WAN. When this parameter is set to lan, all SNMP v2 and inform traps use the source IP address of the primary
LAN interface. Otherwise, the IP address of the WAN interface is used.
system syslog enable { yes | no }
no system syslog enable
show system syslog enable
Note: These commands are supported beginning with Firmware Version 8.2.