Filter
Top Products
Motorola Netopia® Router CLI Commands 2-43
Generic WAN Interface configuration commands
Note: For possible values of intf-type, refer to “Interface Naming Conventions” on page 1-3. Generic WAN
Interface Commands may be applied to any router WAN interface by specifying the intf-type wan together with
the appropriate interface id. Alternatively, you can specify the more specific intf-type if you choose.
interface intf-type id dle { hdlc | ppp [{vcmux | vcmultiplexed | llcsnap}] |
rfc1483 [{ bridged | routed }] | rfc1490 }
show interface intf-type id dle
These commands allow you to set or show the global data link encapsulation type of the interface specified by
intf-type id. At this time you can generally think of the data link encapsulation of interface 1 as the global data
link encapsulation of the router itself.
Note: atmfuni is accepted as a synonym for rfc1483 and frame-relay is accepted as a synonym for rfc1490.
For ppp, the default mode is vcmux. For rfc1483, the default mode for frame-based SDSL (R7100) interfaces
is bridged, while the default mode for cell-based SDSL (R7200) interfaces is routed.
Example:
interface wan 1 dle frame-relay
Generic WAN Interface Configuration Commands
interface intf-type id dle { hdlc | ppp [{vcmux | vcmultiplexed | llcsnap}] |
rfc1483 [{ bridged | routed }] | rfc1490 }
show interface intf-type id dle
show interface intf-type id statistics
show interface intf-type id stats
show interface wan id status
interface wan 0 tracking { yes | no }
Restricted WAN Interface Configuration Commands
interface { adsl | ethernet | isdn | sdsl } id pppoe enable { yes | no }
no interface { adsl | ethernet | isdn | sdsl } id pppoe enable
show interface { adsl | ethernet | isdn | sdsl } id pppoe enable
interface { adsl | sdsl } id pvc { id | tag } { yes | no }
interface { adsl | sdsl } id pvc { id | tag } pcr num
show interface { adsl | sdsl } id pvc { id | tag } pcr