Filter
Top Products
Motorola Netopia® Router CLI Commands 2-49
ADSL WAN Interface configuration commands
interface adsl id pvc vpi-value vci-value
show interface adsl id pvc
These commands allow you to set, change, or show the PVC VPI and VCI values associated with the ADSL WAN
interface.
show interface adsl id status
This command allows you to display the status of the specified ADSL interface. For an ADSL interface, the
possible status strings and their meanings are:
show interface adsl id statistics
Note: This command is supported beginning with firmware version 8.5.
ADSL WAN Interface Configuration Commands
interface adsl id pvc vpi-value vci-value
show interface adsl id pvc
show interface adsl id status
show interface adsl id statistics
interface adsl id signaling-mode { fdm | echo-cancellation }
show interface adsl id signaling-mode
interface adsl id trellis-coding { yes | no }
show interface adsl id trellis-coding
no interface adsl id trellis-coding
Status String Meaning
Connected at xxx rx / yyy tx Kbps The interface is connected to the DSLAM at the specified
speeds, where xxx is the downstream (receive) speed and yyy
is the upstream (transmit) speed, each in Kbps.
Activation Backoff The ADSL interface is between connection attempts.
Down The ADSL interface is not yet initialized.
No signal from DSLAM The ADSL interface is not detecting a signal from a DSLAM.