Filter
Top Products
2-76 Command Line Interface Commands Reference
ip route { ip-addr/mask-bits | ip-addr mask } gw-ip-addr [{ high | low }]
[advertise [{no | distance}] [{enable | disable}]
no ip route { ip-addr/mask-bits | ip-addr mask } gw-ip-addr
show ip route [{ static | ip-addr | ip-addr/mask-bits | ip-addr mask }]
The ip route and no ip route commands allow you to add, change, or delete static routes. The show ip route
static form of the show ip route command displays the configured static routes (including invalid or disabled
ones), while the other forms of the show ip route command display the router's IP routing table (including any
installed (i.e., valid and enabled) static routes).
The destination network may be specified as an IP address and mask in either prefix or dotted-quad notation.
gw-ip-addr is the IP address of the next-hop router, and should be on one of the router's directly connected IP
subnets.
The keywords high and low control the priority of the static route relative to an identical route learned via RIP. A
static route with high priority (the default) takes precendence over an identical route learned via RIP, while an
identical route learned via RIP takes precedence over a static route with low priority.
The keyword advertise controls whether or not the router will advertise (redistribute) the static route via RIP.
The keyword advertise may be followed by a RIP metric (distance) between 1 (the default) and 15 inclusive.
If the show ip route command includes an optional IP address or IP address and mask, the route, if any, in the
IP routing table that pertains to the specified destination network, subnetwork, or host address is displayed.
Examples:
ip route 192.168.2.0/24 192.168.1.123 low advertise
no ip route 192.168.2.0 255.255.255.0 192.168.1.123
show ip route
show ip route static
Note: Beginning with Firmware Version 8.2, the ip route commands will no longer show or set static routes
that are default gateways. They will only operate on direct routes (IP address and mask are non-zero). The
default gateway routes are now meant to be handled with two commands: 1) ip gateway, which configures the
Primary Default Gateway, and 2) backup gateway, which configures the Backup Default gateway.
GMT +1:00 Central Europe Time GMT +11:00 Russia Zone 10
GMT +2:00 Eastern Europe Time GMT +12:00 Russia Zone 11
GMT +3:00 Moscow time (MSK)