Filter
Top Products
Setup Wizard
About
The Setup Wizard is used for the terminal's initial setup but will also run after resetting the unit
back to its factory defaults. To reset the unit back to its defaults, refer to the System section
under
Configure Terminal Properties.
You can use the Setup Wizard to set the basic terminal network configuration and display
parameters however; any of these parameters can be changed later by entering the “Control
Panel” and selecting the appropriate icon.
There are several dialog and configuration boxes, as shown below, that you must navigate
through to complete the Setup Wizard process.
To display the next dialog box in the sequence:
• Click the Next or Accept buttons
To return to the previous dialog box:
• Click the Back button
To quit and go directly to the Desktop:
• Click the Cancel button
Welcome Window
This dialog box shows product information.