Filter
Top Products
Starting a Session
There are three ways to start a NLynx emulation session.
Method 1. Autostart a Session on Power Up
Using the “Connection Startup Dialog Box”, you can pre-set sessions to automatically
connect to their servers when terminal is turned on.
1. From the terminal desktop, click on the “Connection Manager” icon (shown below) to
bring up the “Terminal Connection Manager” setup window. This is the same as
selecting Start > Programs > Connection Manager from the Taskbar Menu.
2. Once the Connection Manager window is open, select the Configure tab.
3. Select a session that you want to Startup when the MinIT6000 is turned on and click on
the "Startup" button.
Connection Startup Dialog Box
4. Place a check mark by the Make the selected connection your default connection option if
you want this session to be your default connection.
5. Place a check mark by the Automatically start the selected connection at startup option to
enable the Autostart function.
6. Adjust the auto-start delay time by changing the "seconds" value. This might be
important in some networks because it allows the unit enough time to obtain DHCP
information from the DHCP server (if set for) before it tries to connect to the host.
7. Click the OK button to complete the setup.
8. Repeat steps 3 - 7 for any additional sessions that you would like to auto-start.
9. Click on the X to close the Connection Manager
Method 2. From the Connection Manager
1. From the terminal desktop, click on the “Connection Manager” icon (shown below) to
bring up the “Terminal Connection Manager” setup window. This is the same as
selecting Start > Programs > Connection Manager from the Taskbar Menu.
2. Once the Connection Manager window is open, select the Connections tab.