Filter
Top Products
Chapter 2 - SmartController Installation
28 Adept SmartController User’s Guide, Rev. E
Stacking Components
To stack mount the SmartController and an sDIO or sMI6 module, install two brackets on
each side of the units, as shown in Figure 2-4. These brackets are supplied with the sDIO
and sMI6 modules.
Figure 2-4. Stack Mounting the SmartController and sDIO
CompactFlash Memory Card
The SmartController is equipped with a CompactFlash™ (CF). The SmartController
system uses a CF in place of a traditional hard disk drive. In fact, it is often referred to as a
“solid state hard drive”. The CF is about half the size of a credit card and twice as thick. It
has no moving parts and is therefore reliable and durable. It is also removable and can be
moved to another SmartController for replacement or testing.
The CF capacity shipped with all systems is currently 30 MB and is factory configured by
Adept. The CF stores the V
+
operating system, optional AIM software, application
programs, data files and Adept licenses.
NOTE: Adept reserves the right to increase the size of the CF without
notice.
76.5
30.7
120.9
8X M3 x 6MM
BOTH SIDES
28.1
16.0
2X 40356-00002
BOTH SIDES
186.5
133.0
328.9
SW1
SmartController CS
XSYS
OK
LINK
XDC1 XDC2
24V 0.5A
HPE
1.1 1.2
X2
1.1 1.2
SC-DIO
Device Net
1 2 3
IEEE-1394
SF
RS-422/485
LAN
XMCP
-+ -+
R
XDC1 XDC2
X3
SF
RS-232/TERM
-+ -+
*S/N 3561-XXXXX*
IEEE-1394
ES
24V 5A
XFP
OK
X4
ON
HD
Eth 10/100
OFF
1 2 3 4
XUSR
R
XDIO
X1
*S/N 3563-XXXXX*