Filter
Top Products
Alteon OS Command Reference
Chapter 6: The Configuration Menu
26140M2420, April 2007
/cfg/l3/nwf
Network Filter Configuration
[IP Network Filter 1 Menu]
addr - IP Address
mask - IP Subnet mask
enable - Enable Network Filter
disable - Disable Network Filter
delete - Delete Network Filter
cur - Display current Network Filter configuration
Table 6-66 IP Network Filter Menu Options (/cfg/l3/nwf)
Command Syntax and Usage
addr <IP address, such as 192.4.17.44>
Sets the starting IP address for this filter. The default address is 0.0.0.0.
mask <subnet mask, such as 255.255.255.0>
Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to define the range of IP
addresses that will be accepted by the peer when the filter is enabled. The default value is 0.0.0.0.
For Border Gateway Protocol (BGP), assign the network filter to a route map, then assign the route
map to the peer.
enable
Enables the Network Filter configuration.
disable
Disables the Network Filter configuration.
delete
Deletes the Network Filter configuration.
cur
Displays the current the Network Filter configuration.