Alteon OS Command Reference
42
Chapter 2: First-Time Configuration 40M2420, April 2007
4. At the prompt, decide whether to make the changes permanent:
Enter
y to save the changes to flash. Enter n to continue without saving the changes. Changes
are normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort them:
Enter
y to discard the changes. Enter n to return to the “Apply the changes?” prompt.
NOTE – After initial configuration is complete, it is recommended that you change the default
passwords as shown in “Setting Passwords” on page 43.
Optional Setup for Telnet Support
NOTE – This step is optional. Perform this procedure only if you are planning on connecting to
the GbE Switch Module through a remote Telnet connection.
1. Telnet is enabled by default. To change the setting, use the following command:
2. Apply and save SNMP and /or telnet configuration(s).
Save changes to flash? [y/n]
Abort all changes? [y/n]
>> # /cfg/sys/access/tnet
>> System# apply
>> System# save