Filter
Top Products
Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1
139
4.6.3 Set the Network Descriptor Parameters
modify command The ipsec connection network modify command sets or modifies the
Network Descriptor parameters.
Example In this example, the parameters of the previously defined network, named net1, are
set:
In the example above, the network is defined as an IP subnet 10.0.0.0/24. No
protocol or port number are selected. The TAB key was used to show the supported
entries for the proto and port parameters.
Use the
list command to verify the results of the operation:
[ipsec connection network]=>
[ipsec connection network]=>modify
name = net1
[type] =
address subnet range
[type] = subnet
[ip] = 10.0.0.0/24
[proto] =
ah egp esp
ggp gre hmp
icmp igmp pup
rdp rsvp tcp
udp vines xns-idp
6to4
[proto] =
[port] =
at-echo at-nbp at-rtmp
at-zis auth bgp
biff bootpc bootps
chargen clearcase daytime
discard dns domain
doom echo exec
finger ftp ...
[port] =
:IPSec connection network modify name=net1
[ipsec connection network]=>
[ipsec connection network]=>list
[net1] : subnet 10.0.0.0/24
[ipsec connection network]=>