Filter
Top Products
Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1
149
4.7.6 Start a Connection
start command The ipsec connection start command triggers the establishment of a
Security Association. If no IKE Security Association between the SpeedTouch™ and
the remote Security Gateway exists, the Phase 1 negotiation is started, followed by
the Phase 2 negotiation. If an IKE SA already exists, the Phase 2 tunnel negotiation
is started immediately.
Example In this example the connection, named connect1, is started:
The result of this operation is verified with the commands of the
show command
group.
[ipsec connection]=>
[ipsec connection]=>start
conn = connect1
:ipsec connection start conn=connect1
[ipsec connection]=>