Filter
Top Products
Chapter 5
Troubleshooting SpeedTouch™ IPSec
E-DOC-CTC-20051017-0169 v0.1
161
5 Troubleshooting SpeedTouch™ IPSec
Introduction IPSec is a complex protocol suite and therefore the SpeedTouch™ offers a number
of troubleshooting methods.
Both the Web pages and the CLI interface allow you to check whether a tunnel setup
was successful or has failed.
Via the CLI you can check the Syslog messages showing you the history of tunnel
negotiation. Each Syslog message has a timestamp attached.
By contacting the SpeedTouch™ using the SNMP protocol, you can access the
IPSec MIB containing a lot of detailed tunnel information.
In this section The following topics are discussed in this section:
Topic Page
5.1 Via the Debug Web pages 162
5.2 Via the CLI: Show command group 165
5.3 Via the CLI: Debug command group 167
5.4 Via SNMP 170