Filter
Top Products
Chapter 3
Configuration via Local Pages
E-DOC-CTC-20051017-0169 v0.1
44
Identification &
Interface
The Identification & Interface fields have to be filled out with the following
information:
Local ID Type and Local ID:
The Local ID identifies the local SpeedTouch™ during the Phase 1 negotiation
with the remote Security Gateway. This identity must match the settings in the
remote Security Gateway in order to successfully set up the IKE Security
Association. The identity types supported in the SpeedTouch™ are listed in
the table below.
Remote ID Type and Remote ID:
The Remote ID identifies the remote Security Gateway during the Phase 1
negotiation. This identity must match the settings in the remote Security
Gateway in order to successfully set up the IKE Security Association. The
identity types supported in the SpeedTouch™ are listed in the table below.
Identity type Keyword Examples
IP address addr 10.0.0.1
Fully qualified domain
name
fqdn sales.corporate.net
User fully qualified domain
name
userfqdn john.doe@corporate.net
Distinguished name dn dc=corpor,uid=user
Key identity keyid myid
If you encounter problems during the IKE negotiations, use the Debug >
Logging page to verify that the Identity Type and Identity of the two peer
Security Gateways correspond with each other.