Filter
Top Products
216 Install and configure IP Trunk 3.01 (and later) node
Figure 49
Wiring specifications
—End—
Configure IP Trunk 3.01 (and later) data
First, configure D-channels, Route Data Blocks, and trunks through the
system TTY. Then configure the ESN data blocks to implement the network
dialing plan and translations. Record the D-Channel, CHIDs, and TNs
for the IP Trunk 3.01 (and later) trunks on the IP Trunk 3.01 (and later)
Installation Summary Sheet.
To configure IP Peer Networking Virtual Trunks, refer to IP Peer Networking
Installation and Commissioning (NN43001-313). Record the first CHID for
the Virtual Trunks on the Virtual Trunk Installation Summary Sheet.
Configure the ISL D-channel on the system for the DCHIP card for IP
Trunk 3.01 (and later)
For the IP Trunk 3.01 (and later) application, use LD 17 to configure the ISL
D-channel for the DCHIP card in Large Systems.
LD 17 Configure the ISL D-channel for the DCHIP card (Large Systems)
Prompt Response Description
REQ CHG Add new data.
TYPE ADAN Type of data block.
ADAN NEW DCH x Action Device and Number, where:
x = 0-255
CTYP MSDL Multi - purpose Serial Data Link card type.
Set MSDL switch settings for the ISL DCH port to RS-422.
GRP
x
Network Group number, where:
x=0–4
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.