Filter
Top Products
ITG shell command set 399
CAUTION
Never connect to the front and back serial ports at the same time.
All ITG shell commands are case-sensitive.
Commands are grouped into eight categories, as shown in Table 61
"General purpose commands" (page 399) – Table 66 "DCHIP-only
commands" (page 405).
Table 61
General purpose commands
Command
Description
cardReset
Perform a warm reboot of the IP trunk card. The card has to be
in the OOS state to use this command.
itgCardShow
Show card information.
ldrResTableShow
Show Backup Leader and Followers for a given Leader.
itgChanStateShow
Show state of channels (for example, busy or idle).
h323SessionShow
Show H.323 session information for each channel.
itgMemShow
Show memory usage.
ifShow
Show detailed network interface information, including MAC
and IP addresses.
IPInfoShow
This command will return the following IP information:
• IP addresses (for both ELAN and TLAN network interfaces)
•
default router (for both ELAN and TLAN network interfaces)
•
subnet masks (for both ELAN and TLAN network interfaces)
•
SNMP manager
cardStateShow
IP trunk card state (that is Unequipped, Disabled, Enabled).
serialNumShow
Print out IP trunk card serial number and PEC.
This command displays the same IP trunk card serial number
that is displayed from the system IDC command, and the
Product Engineering Code (PEC).
firmwareVersionShow
Print out firmware version number.
numChannelsShow
Print out number of available channels.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.