Add an IP Trunk 3.01 (and later) node 303
Figure 94
New ITG node General tab
7
On the General tab, on the left side of the window, define the
following from the drop-down lists:
•
The TM 3.1 site – the name that was assigned when the site was
created. See "Add a site and system" (page 282).
•
The TM 3.1 system name – the name of the system associated
with this site. See "Add a system" (page 289).
•
The Customer number.
• The Node number – there might be several nodes; this
differentiates between them.
8
On the right side of the window, enter the following information:
•
Voice LAN Node IP – the Leader IP address for call processing
• Management LAN gateway IP – the lowest valid IP address on
the LAN segment of the Management Server
•
Management LAN subnet mask – the ELAN subnet mask
•
Voice LAN subnet mask – the TLAN subnet mask
Provision the IP trunk cards
9
Click the Configuration tab. This is where the IP trunk cards are
provisioned. See Figure 95 "New ITG Node - Configuration tab"
(page 304).
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.