Filter
Top Products
Configure IP Trunk 3.01 (and later) data 223
Prompt Response Description
NCNA (YES) NO Network Calling Name allowed.
NCRD (NO) YES Network Call Redirection allowed.
CTYP Call type for outgoing call dialed with the route access
code (ACOD).
Set to appropriate call type for IP Trunk 3.01 (and later)
node numbering plan in order to make test calls using
ACOD.
INAC (NO) YES INAC stands for automatic insertion of the ESN access
code on incoming calls, according to ISDN call types
corresponding to NPA NXX INTL SPN LOC, for example.
Using INAC=YES can simplify the configuration of the
ESN RLBs and DGT. Nortel recommends this for MCDN
features with non-call-associated signalling (for example,
NMS, NACD, NRAG).
By default, the INAC feature places all ESN call types
except for CDP under AC1. If any call types must go
under AC2 for INAC, use LD 15 to configure them at the
AC2 prompt at the Customer Data Block.
...
ICOG Incoming or outgoing trunk.
IAO Incoming and outgoing.
SRCH LIN Linear search method.
See Note 1.
SIGO (STD) Standard signaling arrangement.
ESN5 ESN 5 signaling
Unless ESN5 is used, SIGO (outgoing signaling protocol)
must be set to STD.
If SIGO equals ESN5:
(1) Select SL1ESN5 from the pull-down list in the Protocol
field in the ITG Node Properties configuration tab.
(2) Select SL1ESN5 from the pull-down list in the Remote
Capabilities field in the TM 3.1 Node Dialing Plan General
tab for each destination node that uses ESN5.
CNTL YES
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.