Filter
Top Products
370 OA and M using the ITG shell CLI and overlays
Procedure 62
Changing the default ITG shell password
Step Action
1
From the ITG shell use the command shellPasswordSet to
change the default user name and password for Telnet to ITG shell
and FTP to the IP trunk card file system. The default user name is
itgadmin and the default password is itgadmin.
2
Enter the current user name when prompted:
Enter current username: itgadmin
Enter current password: itgadmin
Enter new username: new name
Enter new password: new password
Enter new password again to confirm: new password
—End—
If the complete sequence of commands is correctly entered, the system
response value = 0 = 0x0 appears. The new user name and password
are now stored in non-volatile RAM on the IP trunk card and retained when
the card is reset or power-cycled.
Reset the default ITG shell password
If the ITG shell password is lost, the ITG shell user name and password can
be reset to the default: itgadmin. This procedure requires physical access
to the IP trunk card. This procedure cannot be done through Telnet.
Follow the steps in Procedure 63 "Resetting the default ITG shell password"
(page 370) to reset the default ITG shell password.
Procedure 63
Resetting the default ITG shell password
Step Action
1
Connect a terminal to the IP tr unk card maintenance port.
2
Press the reset button on the IP trunk card and observe the
sequence of startup messages from the card.
3
Look for the prompt screen to enter the BIOS ROM.
There is a window of only approximately 2-3 seconds to enter the
correct prompt (jkl for the Media Card 32-port trunk card and jkl
for the
ITG-Pentium 24-port trunk card).
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.