Filter
Top Products
Add an IP Trunk 3.01 (and later) node 307
Figure 97
New ITG Node, DSP Profile tab, General sub-tab Profile 1
13
Select the applicable DSP Profile information. There are three
choices in the DSP Profile drop-down list, as seen in Figure 97
"New ITG Node – DSP Profile tab - General sub-tab - Profile 1"
(page 307).Click Apply.
CAUTION
Service Interruption
The Media Card 32-port trunk card does not support
Profile 3. If Profile 3 is provisioned, the card is unable to
make or receive calls.
The DSP Profile values appear. See Figure 98 "DSP Profile sub-tabs
– Profile 1 Options sub-tab" (page 308).
Some of the values that can be changed are:
•
DTMF tone detection – for voice mail access and IVR, for
example. Allows DTMF tones to be reliably transmitted across
the network. See "DTMF Through Dial" (page 69).
•
Enable echo canceller – enables echo in calls, on by default
•
Echo canceller tail delay – by default, the value is 128 ms
•
V.21 fax tone detection – allows fax calls to be transmitted as
data and not as voice packets. When the fax call is transmitted
as data (T.30), the call has a much greater chance of success.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 01.01 Standard
Release 5.0 30 May 2007
Copyright © 2007, Nortel Networks
.