Filter
Top Products
Installing Processor and Interface Cards and Connecting Equipment
308684-B Rev 00
4-33
To connect a modem to the Versalar 15000:
1.
Turn on and configure the modem, using the parameters in Table 4-4.
Refer to the modem documentation for instructions.
Table 4-4. Modem Settings
Setting Value
Clear to send (CTS) signal On
Data terminal ready (DTR) signal Modem will only connect if the DTR signal is
present. If the DTR signal is not present, the
modem will disconnect.
Data carrier detect (DCD) or
received line signal detection
(RLSD)
On while the carrier is present. The Versalar
15000 uses DCD to detect modem connect and
disconnect.
Data set ready (DSR) signal On
Ready to send (RTS) signal Ignored
Synchronous/asynchronous mode Asynchronous
Auto answer Answer on two rings when DTR is active.
Local character echo Off
Supervisory functions Off
Baud rate 9600
Data bits 8
Stop bits 1
Parity None