Nortel Networks P0990474 03 Switch User Manual


 
Chapter 5 Initializing the CallPilot Mini/CallPilot 150 37
CallPilot Mini/CallPilot 150 Installation and Maintenance Guide
5 Remove power from the CallPilot Mini/CallPilot 150.
6 Reconnect power to the CallPilot Mini/CallPilot 150.
The prompt
To change any of this, press any key within 5 seconds
appears.
7 Press the Enter key.
The prompt
(M)odify any of this or (C)ontinue?
appears.
8 Press the M key and press the Enter key.
The prompt
Do you want a LAN interface?
appears.
9 Press the Y key and press the Enter key.
The prompt
This board’s LAN IP Address (0.0.0.0 = RARP)
appears.
10 Type the IP address for the CallPilot Mini/CallPilot 150 in a valid dotted format and press the
Enter key.
The prompt
Subnet mask for LAN (0 for none)
appears.
11 Type the Subnet Mask for the CallPilot Mini/CallPilot 150 in a valid dotted format and press
the Enter key.
The prompt
Should there be a default gateway for packet routing?
appears.
12 If the CallPilot Mini/CallPilot 150 needs a next hop router, press the Y key and press the
Enter key.
If the CallPilot Mini/CallPilot 150 does not need a next hop router, press the N key, press the
Enter key and go to step 15.
The prompt
IP address of default gateway?
appears.
13 Type the IP address of the next hop router in a valid dotted format and press the Enter key.
14 Press the Enter key until the following prompt appears.
(M)odify any of this or (C)ontinue?
15 Press the C key and press the Enter key.
16 Connect the LAN cable to the Ethernet port on the CallPilot Mini/CallPilot 150.
You can now initialize the CallPilot parameters. For information about how to initialize the
CallPilot, refer to “Running the Quick Install Wizard” on page 39.
Note: Steps 5 and 6 are used to force the CallPilot Mini/CallPilot 150 to reboot. You
can change the IP address only while the CallPilot Mini/CallPilot 150 is booting up.
Note: It will take approximately one minute for this prompt to appear.
Note: If you do not press a key within 5 seconds of this prompt appearing, repeat
steps 5 and 6.