Filter
Top Products
PC Utilities Chapter 4
SMART-AG User Manual Rev 2 39
subsequent positions, shown with a yellow + marker, are given relative to this initial starting
point. The current position is shown with a red + marker.
The buttons at the top of the window provide options for controlling the plan display:
• Zoom in or out of the Plan window
• View all configurations or center in on the active configuration
• Select a grid or circular display
• Show/Hide history
• Delete all history (no undo)
To open this window, select Plan Window from the View menu or select its button in the
Window Toolbar.
• Doppler Window: A value representing the uncertainty of the position solution based on
the current satellite geometry. The lower the value, the greater the confidence in the solution.
In the DOP window, DOP is displayed in the following forms:
• GDOP Geometric DOP: Uncertainty of all parameters (latitude,
longitude, height, clock offset)
• PDOP Position DOP: Uncertainty of the three-dimensional
parameters (latitude, longitude, height)
• HDOP Horizontal DOP: Uncertainty of the two-dimensional
parameters (latitude, longitude)
• VDOP Vertical DOP: Uncertainty of the height
• TDOP Time DOP: Uncertainty of the clock offset
• Console Window: This window allows the user to communicate directly to the receiver through
the serial port. It is essentially a terminal emulator with added receiver functionality. Commands
can be issued to the receiver via the command editor (at the bottom of the window) and sent by
pressing the Enter button or simply pressing <Enter> on the keyboard. The command editor has
recall functionality similar to DosKey whereby pressing the up arrow on the keyboard will move
backward through the previously issued commands and pressing the down arrow will move
forward through the previously issued commands. This allows the user to scroll through
previously issued commands and then press the <Enter> key to issue that command again.
Feedback from the receiver is displayed in the ASCII Messages or Console window depending on
the format of the message (ASCII or Abbreviated ASCII respectively).
WARNING!: Ensure all other windows are closed in CDU when entering the SAVECONFIG
command in the Console window.