Filter
Top Products
Technical Specifications Appendix A
SMART-AG User Manual Rev 2 55
• Serial data signals (TxD, RxD, signal ground) must be run in shielded cable.
Connect shields to ground at SMART-AG end only
• CAN signal conductors must be twisted (40 twists/m, 12 twists/ft)
• Use only the recommended mating connectors listed below. Use only gold plated
pins
WARNING: Failure to observe the given cable construction guidelines in this section will
result in damage to the wiring (not covered by warranty).
The connector used in the SMART-AG is an “AMPSEAL” dust and water type produced by Tyco.
The following part numbers pertain to the mating connector required to make connections to the
SMART-AG. These numbers are provided for information only and are not available from NovAtel as
seperate parts.
Table 8: SMART-AG Mating Connectors
Table 9 details the part numbers for recommended fuses and fuse holders. These numbers are provided
for information only and are not available from NovAtel as seperate parts.
Product Part Description Company Part Number
SMART-AG mating connector
(Figure 15 on Page 53)
14-pin sealed
receptacle housing-
black
Tyco/AMP 776273-1
SMART-AG mating connector
(Figure 15 on Page 53)
14-pin sealed
receptacle housing-
natural
Tyco/AMP 776273-2
SMART-AG mating connector
(Figure 15 on Page 53)
14-pin sealed
receptacle housing-
grey
Tyco/AMP 776273-4
SMART-AG mating connector
(Figure 15 on Page 53)
14-pin sealed
receptacle housing-
blue
Tyco/AMP 776273-5
Gold plated pins for SMART-AG
connector/loose
Pins, loose piece Tyco/AMP 770854-3
Gold plated pins for SMART-AG
connector/strip
Pins, strip (reel) Tyco/AMP 770520-3