Filter
Top Products
PRINTER DRIVERS > 12
5.
The printer will be identified
immediately by the New Hardware
Wizard and install itself in the Printer
folder. An additional item, USB Printing
Support will also appear in the Device
Manager each time the printer is
switched
ON
and connected.
6.
Check that the default paper size has
been correctly set by looking at the
settings in the Settings > Printers folder.
Under the printer's Properties > General
tab, the current paper selection is
shown. The printer picks up its initial
setting from the Locale settings on the
host computer. The paper size can be
altered by using the drop down arrow
and selecting an alternative size.
7.
If the printer had formerly been used as a parallel or serial
device and there is no output from the printer once a USB
cable has been connected, check to see that the correct port
has been selected. This information can also be found in the
Properties folder but under the Ports tab. Amend as necessary.
8.
If there are printing problems, check to see whether there is a
USB connection active in the Control Panel. If there is no USB
connection shown, you must install the hub.
9.
Alternatively, there may be a problem if the printer is
connected via a USB hub. Disconnect the printer cable from
the hub and connect it directly to the computer.