Filter
Top Products
MENU MODE > 40
Print Registration, Default = 0
Change the setting as required to obtain the best registration for bi-
directional printing.
Print Suppress Effective, Default = Yes
If your system uses the DC1 and DC3 codes for something other than
the print suppress mode, change the setting to
No
.
Proportional Spacing, Default = No
Change the setting to Yes to engage proportional spacing of
characters.
Protocol, Default = Ready/Busy
Appears only if the optional Serial Interface is installed. Change to
X-ON / X-OFF if that is the type of protocol your system uses.
Receive Buffer Size, Default = 64K
Selects the amount of memory devoted to holding received data.
Choosing 1 Line will tie up your computer while printing, but if you
abort the print job, the printer will stop much sooner.
Reset Inhibit, Default = No
Select Yes if you wish the printer to ignore the reset command sent by
software. This prevents your software from changing the settings you
make through the front panel controls or through printer commands.
Serial Data 7/8 Bits, Default = 8 Bits
Appears only if the optional Serial Interface is installed. Change to 7
Bits if your system uses a 7-bit data format.
NOTE
This will also prevent your software from clearing out existing settings
when you finish printing one document and switch to another.