Filter
Top Products
MENU MODE > 37
DSR Signal, Default = Valid
Appears only when the optional Serial Interface is installed. Used with
the Ready/Busy protocol (factory default) to select the way your
system handles the DSR signal.
DTR Signal, Default = Ready On Power Up
Appears only when the optional Serial Interface is installed. Change
to Ready On Select if the DTR signal is required when the printer is
selected (leave as Ready On Power Up if the DTR signal is required
when the printer is turned ON).
Emulation Mode, Default = IBM PPR
Selects the printer command set (emulation) you want to engage.
ESC SI Pitch, Default = 17 cpi
Sets the character pitch used when the ESC SI command is received.
Form Tear-Off, Default = Off
Choose 500 ms, 1 sec, or 2 sec to turn the Form Tear-Off feature ON
and to set the time interval for the printer to wait before advancing the
paper.
Graphics, Default = Bi-directional
Change to uni-directional graphics for better registration, but slower
printing. With this set for bi-directional, you can optimise the
registration using the Print Registration setting in the Menu.
I-Prime, Default = Buffer Print
Determines what the printer will do when it receives the I-Prime signal
from the software.
l
Buffer Print
: prints out the buffer contents before resetting.
l
Buffer Clear
: dumps the buffer contents immediately.
l
Invalid
: causes the printer to ignore the I-Prime command.
Select this setting if you wish to enter settings through the
printer’s control panel which will not be automatically