Filter
Top Products
USING YOUR PRINTER > 18
TEMPORARILY CHANGING THE TOP OF FORM
To move the Top of Form position lower for one page only:
1.
Press
SEL
to deselect the printer.
2.
Press
LF
to lower the position of the Top of Form.
RESETTING TOP OF FORM TO THE FACTORY DEFAULT
The factory default setting for the Top of Form (where the printing
should begin) is 1" down from the top of the page.
To reset the Top of Form to the factory default:
1.
Remove paper from the paper path.
2.
Turn the printer off.
3.
Press and hold
PARK
+
QUIET | TOF
while turning on the
printer.
4.
Reload paper.
FORMS TEAR-OFF FEATURE
This feature is normally turned off. To use Forms Tear-Off, you must
enter the menu and change the setting to the desired time interval
(see “Changing the Forms Tear- Off Settings”).
The Forms Tear-Off feature allows a printed continuous forms page to
be torn off without wasting paper or adjusting the printer. It can be
used for rear feed continuous forms, bottom feed continuous forms
(with the optional push tractor installed), or for top feed roll paper
(with optional roll paper stand installed).
When the printer is turned on, the paper feeds to the tear-off position.
CAUTION!
Do not use the platen knob to change the Top of Form. If you turn the
platen knob when the printer is not at Top of Form, the TOF will
misalign. Always feed the paper to TOF before turning the platen knob!