Filter
Top Products
USING YOUR PRINTER > 16
SETTING TOP OF FORM (TOF)
The first line prints at the red line of the plastic paper shield on the
printhead.
Forms Tear-Off set to OFF - (default)
With paper loaded and the printer ON:
1.
Press
PARK
(6) to park the paper.
2.
Press
FF/LOAD
(4) to load the paper.
3.
If the printer is ON line, press
SEL
|
MENU
(1) to take the
printer
OFF
line.
The SEL light goes out.
4.
Press and hold
SHIFT
(2), then:
l Press
LF | Micro Feed Down
(3) to set the TOF
higher
(the
paper moves down).
l Press
FF/LOAD | Micro Feed Up
(4) to set the TOF
lower
(the paper moves up).
(When you begin pressing the Micro Feed key, the printhead will move
to the right).
5.
Press
SEL | MENU
(1) to place the printer back on line.
To reset the Top of Form to the factory default, see “Resetting Top of
Form to the Factory Default” later in this chapter.
CAUTION!
Do not use the platen knob to change the Top of Form. If you turn the
platen knob when the printer is not at Top of Form, the TOF will
misalign. Always feed the paper to TOF before turning the platen knob.
1
2
3
4
6
75