TROUBLESHOOTING > 66
Problem
There are dots missing in my printouts.
Solution
The head gap may not be set correctly. Try moving the headgap lever
to a lower setting. If that doesn’t help, the printhead may be
damaged; call for service.
Problem
The ALARM light is flashing.
Solution
Try turning the printer
OFF
and then back
ON
again. If the light still
blinks, call for service.
Problem
The ALARM light is ON and the Character Pitch 10 light is flashing.
Solution
This indicates that the paper lever is set at the wrong position for the
paper you are trying to use. Move it to the proper setting.
Problem
The ALARM light is ON and the Character Pitch 15 light is flashing.
Solution
This indicates a paper jam. Press the
SEL
key and correct the paper
jam situation. See “Clearing Paper Jams,” in Chapter 3.
Problem
The printer needs paper. The ALARM is not ON and I can’t load paper.
Solution
1.
Press and release the
SEL
key.
2.
Press and hold the
SHIFT
key and press the
RESET /
CHARACTER PITCH
key.
The
ALARM
light illuminates and you can now load paper.