Filter
Top Products
48
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Preparing for Installation
Unpacking and Inspecting
Immediately after receiving the equipment, examine all shipping containers and
contents for damage. If any damage has occurred, notify the shipping carrier.
Unpack the unit by removing the packing material and lifting it from its protective
enclosures. Visually examine the equipment and check the container for related
parts and accessories. You should have the following items:
•
One CrossFire 8600 Token-Ring Switch
OR
One CrossFire 8605 Token-Ring Fiber Switch
•
One
CrossFire 8600/8605 Token-Ring Switches Guide to Operations
(this guide)
•
One OC-8830 Token-Ring Switch Program Disk Set
•
One OC-8840 Token-Ring Switch Manager for HP OpenView for Windows
(also works as stand-alone without HP Open View under Windows).
•
One
CrossFire 8600 Series Token-Ring Switch Manager
for HP OpenView for Windows Guides to Operations
•
One serial cable for the management port
•
One plastic bag containing four adhesive rubber feet and rack mounting
screws, Allen key, nuts and washers.
Report any missing parts and any damage not related to shipping to your customer
service representative.
➽ Note:
Keep the packing materials for future use.
All components returned under
warranty should be shipped in their original packing materials.
If you have received your equipment before your site is fully prepared, after
inspection, you should keep all of the components in the original shipping
containers and store them in a physically and environmentally safe place.
When you are ready to begin the installation, please refer to the next chapter,
Chapter 4, “Installation”, for important instructions and directions.