Filter
Top Products
E-28
General Operation
This section describes the use of direct operation with the main unit or remote control buttons.
For information about operation using the menu, see “Menu Operation Method” on Page E-37 and
the various items on Pages E-46 to E-60.
Input Selection
This operation selects the input signal to be projected.
Main unit operation: Press the SOURCE button.
(It will not function while the menu or the quick menu is displayed.)
When Auto Source is On
If there is no input signal at the source that was previously used,
the projector automatically selects the next source that has an
input signal.
When Auto Source is Off
Each press of the button switches the selection one step in the
sequence of Analog RGB → YPbPr → Digital RGB → VIDEO →
S-VIDEO → YCbCr.
Remote control operation: Press the desired input se-
lection button.
When Auto Source is On
When an input signal is not present at the selected source, the
projector automatically selects the next source that has an input
signal.
When Auto Source is Off
The projector switches to the selected source regardless of
whether an input signal is present.
MENU
AUTO
SOURCE
QUICK
MENU
ON OFF
FREEZE MUTE PIP
DIGITAL RGB YPbPr
VIDEO S-VIDEO YCbCr
QUICK ASPECT AUTO
POWER
Note
* When you do not operate source selection, the projector will assume the input selection condition that was
previously used.
* See “Auto Source” on Page E-55 for information about the Auto Source on and off conditions.
* YPbPr input selection cannot be used when YPbPr is set to “Disable”. See “YPbPr” on Page E-57.