Filter
Top Products
23
First Time Setup
To use the AccuClock function, the CD/HDD receiver must be able to receive RDS radio stations, which means an FM
antenna must be connected. Be sure to connect an FM antenna before attempting to use this function (see page 17).
The very first time you turn on the CD/HDD receiver, the AccuClock function automatically sets the CD/HDD
receiver’s clock based on the CT (Clock Time) information present in an RDS radio broadcast. While the clock is being
set, “Wait…” appears on the display, as shown. Note that it may take up to 5 minutes to set the clock.
When the clock has been set, the message “Clock Adjusted” scrolls across the display, then the day and time are dis-
played for a while, as shown.
The AccuClock function automatically updates the clock daily at 2 A.M., 3 A.M., and 2 P.M.
If for some reason the clock cannot be set automatically, see “Setting AccuClock to Use a Specific Station” on page 62
and “Setting the Clock Manually” on page 63.
Turning Off the AccuClock Function
If you don’t want AccuClock to automatically update the clock each day, you can turn it off as follows.
Note:
The AccuClock function cannot be turned off until the clock
has been set.
Setting the Clock with the AccuClock Function
W
ait . . .
00
:
01
.
2008 . 01 . 01
ENTER
TIMER
/
1
Press the [TIMER] button.
2
Press [ENTER] with “Clock”
selected.
The sub-menu appears and the CD/HDD
receiver enters clock setting mode.
3
Use the Up and Down [ ]/[ ] but-
tons to select “AccuClock”, and
then press [ENTER].
4
To turn off AccuClock, press the
Up or Down [ ]/[ ] button until the
asterisks disappear.
The AccuClock function is off. To turn
AccuClock back on again, press the Up
or Down [ ]/[ ] button so that the aster-
isks are displayed.
Timer 2
Timer 1
Clock
C
l
ock
RDS
-
CT
Station
: FM 87.50MHz
The asterisks indicate that the
AccuClock function is on.