Filter
Top Products
24
Basic Operations
You can select HDD, CD, AM, FM, or a connected component (LINE 1, TAPE, DOCK, USB or DIGITAL) as the input
source.
On the CD/HDD receiver, press the [INPUT
SELECTOR] button repeatedly.
The input sources are selected in the following order.
* Input Display can be changed (see page 45).
Tip:
You can also use the CD/HDD receiver’s MULTI JOG
dial to switch the input source while any input source is
displayed.
On the remote controller, press the INPUT
[ ]/[ ] buttons repeatedly.
Each time you press these buttons, you can select the
previous or next input source.
Using other buttons:
HDD button*
Switches to HDD for playback.
CD button*
Switches to CD for playback.
USB button*
Switches to USB for playback.
TUNER (BAND) button
Selects AM or FM as the input source. If you press this
button repeatedly, you can switch the radio band.
* These buttons also work in the Standby mode.
Turn the [VOLUME] control clockwise to
increase the volume or counterclockwise to
decrease it.
You can also use remote controller’s VOL [ ]/[ ] but-
ton.
The default setting is “10”. You can adjust the volume
from MIN, 01 through 41 to MAX.
Turn down the volume, then connect your stereo head-
phones to the PHONES minijack.
You can adjust the volume and mute the sound, as
explained earlier.
The speakers output no sound while the headphones are
connected.
Notes:
• Do not connect the audio output jack of any other device
to the PHONES jack, because it may cause a malfunction
of the device.
• When you use headphones, Onkyo recommend that you
deactivate Audyssey EQ™. About Audyssey EQ™, see
page 26.
Selecting the Input Source
HDD CD USB FM
AM
LINE
DIGITAL*
DOCK* TAPE*
Adjusting the Volume
Remote
controller
CD/HDD receiver
Using Headphones
PHONES jack