Filter
Top Products
106
Redialling
Automatic Redialling
Manual Redialling
You can also redial the last dialed number manually by pressing key.
To redial the last dialed number through memory
To redial the last dialed number through ADF
(see Note 1)
If a busy line is detected, the machine will redial the number up to 2
times at 1 minute interval. However, if a busy line is not detected, the
machine will redial only one time. During that time, a message will
appear as shown to the right.
A file number is shown in the upper right hand corner of the display if it
is a memory transmission file.
1
Set document(s) face down.
Make sure that the MEMORY lamp is on.
2
3
The document is stored into memory with a file number.
Then dials the last dialed number.
1
Set document(s) face down.
2
Make sure that the lamp goes off.
3
Your machine starts dialling the last dialed number.
Note:
1. While the unit is displaying "WAIT TO DIAL", you can press
to start redialling immediately.
WAIT TO DIAL NO.001
(Telephone number)
REDIAL
ENTER STATION(S)
THEN PRESS START 00%
PAUSE
REDIAL
TEL. NO.
5551234
START
* STORE * NO.001
PAGES=001 01%
* DIALLING* NO.002
5551234
ENTER STATION(S)
THEN PRESS START 00%
MEMORY
ENTER STATION
00%
PAUSE
REDIAL
START
PRESS START TO DIAL
5551234
* DIALLING *
5551234
REDIAL
Sending Documents via Telephone Line