Filter
Top Products
82
Manual Number Dialling (see Note 1) (see Note 2)
(see Note 3)
1
Set document(s) face down.
You can temporarily change the transmission settings.
2
To choose Internet communication.
3
Enter the full email address by using Character keys (up
to 60 characters). or enter part of an email address and
use
or
or keys to display the email address you
want to send to.
Ex:
If you make a mistake, press to erase the
character then reenter the correct character.
or
Ex:
The machine will complete the email address. (see Note 3)
4
The document(s) is stored into memory with a file number.
Then starts sending the email message.
Note:
1. If your machine sounds an alarm (pi-pi-pi) at Step 2, this indicates that the Dialer is Full (more than 70 full email
addresses are entered or 70 transmission reservations including G3 communication have been already reserved).
2. If the transmission can not be completed for any reason, the email may be returned undelivered, otherwise no reply
will be printed.
3. For the machine to perform the email address completion the Fax Parameter No. 160 (DEFAULT DOMAIN) must
be set to "Valid" and the DEFAULT DOMAIN must be preprogrammed in the Setting the Internet Parameters (see
page 41).
ENTER STATION(S)
THEN PRESS START 00%
INTERNET
❚
ENTER EMAIL ADDRESS
abc
27
@
p
a n a s o n i c
28
.
com
CLEAR
abc
abc@panasonic.com
abc
START
* STORE * NO.001
PAGES=001 01%
* STORE * COMPLETED
TOTAL PAGES=005 25%
ON LINE * MEM.XMT *
ID:abc@panasonic.com
Sending Documents via LAN