Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
46 - ENGLISH
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press as to select the display language.
ENTER
1/4
Please select DISPLAY LANGUAGE.
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
Set [PROJECTION METHOD] depending on the installation mode. Refer to “Installation mode” (x page 30) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
1) Press qw to switch the setting.
2/4
INITIAL SETTING
FRONT/FLOOR
PROJECTION METHOD
Change the projection method if the screen display is
upside down or inverted.
CHANGE
SET
ENTER
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The default setting is [ECO] that keeps power consumption low during standby. When the network
function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
1) Press qw to switch the setting.
3/4
ENTER
SET
CHANGE
If STANDBY MODE is set to ECO, you cannot use
network functions when the projector is standing by.
Also, you cannot use some RS-232C protocol
commands.
STANDBY MODE
ECO
INITIAL SETTING
2) Press the <ENTER> button to proceed to the initial setting.