Filter
Top Products
Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 47
Note
f The above initial setting screen is the one displayed when the projector is switched on for the rst time after purchase. When [ALL USER
DATA] in the [PROJECTOR SETUP] menu → [INITIALIZE] is executed, the setting of [STANDBY MODE] before execution is displayed.
Initial setting (screen setting)
Set the screen format (aspect ratio) and display position of the image. After completed the initial setting, you can change the settings of each
item from the [DISPLAY OPTION] menu → [SCREEN SETTING].
1) Press as to select an item.
2) Press qw to switch the setting.
16:10
4/4
SCREEN POSITION
Set as necessary for the screen in use.
INITIAL SETTING
SET
CHANGEMENU SELECT
SCREEN FORMAT
ENTER
3) Press the <ENTER> button.
f Conrm the setting value and complete the initial setting.
Note
f If you press the <MENU> button while the initial setting screen is displayed, you can go back to the previous screen.
f By default, the time zone of the projector is set to +09:00 (Japan and Korean Standard Time). Change the setting in the [PROJECTOR
SETUP] menu → [DATE AND TIME] → [TIME ZONE] to the time zone of the region where you use the projector.
Making adjustments and selections
It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
1) 8)
5)
3)
6)
7) 9)
2)
4)
2) 3)
4)
1) Press the <FOCUS> button to roughly adjust the focus of the image. (x page 49)
2) Change the setting of [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 30)
f Refer to “Navigating through the menu” (x page 57) for the operation of the menu screen.
3) Press the <INPUT> button on the control panel or the input selection (<RGB1/2>, <DIGITAL LINK>
*1
,
<DVI-D>, <VIDEO>, <DisplayPort>
*1
, <HDMI>) buttons on the remote control to select the input.
(*1 Only for PT-EZ580, PT-EW640 and PT-EX610)
4) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 37)
5) Press the <SHIFT> button to adjust the position of the image.