Filter
Top Products
12
- ENGLISH
Important
Information
Precautions for Use
Cautions when transporting
When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts.
z
Doing so may damage the internal parts and result in malfunctions.
Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.
z
Cautions when installing
Do not set up the projector outdoors.
J
The projector is designed for indoor use only.
z
Do not use under the following conditions.
J
Places where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts
z
and result in malfunctions.
Near the exhaust of an air conditioner or near lights (studio lamps, etc.) where temperature changes greatly
z
(Operating environment
Æ
page 86): Doing so may shorten the life of the lamp or result in deformation of the
outer case and malfunctions.
Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
z
Be sure to ask authorized personnel or your supplier when mounting the
J
product to a ceiling
This requires an optional ceiling mount bracket.
Product No.: ET-PKF110H (for high ceilings), ET-PKF110S (for low ceilings)
Consult your supplier if you need ceiling mount brackets ET-PKF100H (for high ceilings) or ET-PKF100S (for
z
low ceilings) for projectors PT-F300 or PT-FW300.
Be sure to set [HIGH ALTITUDE MODE] to [ON] when using the projector
J
at elevations of 1400 m (4593 ft) or higher and lower than 2700 m (8858 ft)
above sea level.
Failure to do so may shorten the life of the internal parts and result in malfunctions.
Be sure to set [HIGH ALTITUDE MODE] to [OFF] when using the projector at
J
elevations lower than 1400 m (4593 ft) above sea level.
Failure to do so may shorten the life of the internal parts and result in malfunctions.
Do not install the projector at elevations of 2700 m (8858 ft) or higher above
J
sea level.
Failure to do so may shorten the life of the internal parts and result in malfunctions.
Do not use the projector installed vertically or tilted right or left (
J
Æ
page 21 )
Using the projector at a vertical angle that exceeds 30° may reduce product life or result in malfunction.