Filter
Top Products
56
- ENGLISH
Settings
PROJECTOR SETUP menu
Select [PROJECTOR SETUP] from the Main
Menu (see “Navigating through the menu” on
page 35), then select the item from the sub-
menu.
After selecting the item, press ◄►▲▼ to set.
z
Remote Control
Control Panel
STATUS
Displays the status of the projector.
Press ▲▼ to select [STATUS].1 )
Press the <ENTER> button.2 )
The [STATUS] screen appears.
z
SIGNAL NAME Displays the input signal name.
SIGNAL
FREQUENCY
Displays the frequency of the
input signal.
PROJECTOR
RUNTIME
Displays the projector runtime.
LAMP
Indicates the number of hours
the lamp has been used
SERIAL
NUMBER
Displays the serial number of the
projector.
PROJECTOR ID
The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control.
Press ▲▼ to select [PROJECTOR ID].1 )
Press the <ENTER> button.2 )
The [PROJECTOR ID] screen appears.
z
Press ▲▼ to select [PROJECTOR ID].3 )
Select [ALL] or a number between [1] and [6]
z
from the list that appears.
ALL 1
6 2
Press the <ENTER> button to conrm 4 )
the entry.
The selected [PROJECTOR ID] appears.
z
Note
If the projectors are given ID numbers, their remote
z
controls must be assigned the same ID numbers,
respectively.
If the ID number of a projector is set to [ALL], it can be
z
controlled by the remote control or the PC with any ID
number.
If multiple projectors are used and some of them
have their IDs set to [ALL], they cannot be controlled
separately from the projectors with other ID numbers.
For details on remote control ID setting, refer to “Setting
Remote control ID numbers” (
Æ
page 20).
INITIAL START UP
Use the steps below to select INITIAL START UP
when the projector is connected to a wall outlet.
Press ▲▼ to select [INITIAL START 1 )
UP].
Use ◄► to switch [INITIAL START UP] 2 )
settings.
Each press of the button switches the settings
z
as shown below.
LAST MEMORY STANDBY ON
LAST
MEMORY
Starts up the projector in the mode it
was in when last shut down
STANDBY Starts up in standby mode
ON Starts projection immediately