Filter
Top Products
PROJECTOR SETUP menu
58
- ENGLISH
Settings
SCHEDULE
This sets the command execution schedule for each
day of the week.
How to enable the SCHEDULE
J
function
Press ▲▼ to select [SCHEDULE].1 )
Press ◄► to switch [SCHEDULE].2 )
Each press of the button switches the settings
z
as shown below.
ON OFF
ON Enables set SCHEDULE
OFF Disable set SCHEDULE
Note
If [SCHEDULE] is set to [ON], the setting for [STANDBY
z
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
How to assign a program
J
With [SCHEDULE] switched to [ON], 1 )
press <ENTER> button.
The [SCHEDULE] screen will be displayed.
z
Select and assign program to each day 2 )
of week.
Press ▲▼ to select a day of week and press
z
◄► to select a program number.
You can set the program from No.1 to No.7.
z
“- - -” indicates that the program number has
not been set yet.
How to set a program
J
You can set up to 16 commands to each program.
On the [SCHEDULE] screen, press ▲▼ 1 )
to select [PROGRAM EDIT].
Press ◄► to select a program number 2 )
to be set (Program 1 to Program 7) and
press the <ENTER> button.
Press ▲▼ to select a command 3 )
number (01 to 16) and press the
<ENTER> button.
You can change the page using ▲▼.
z
Press ▲▼ to select [TIME] or 4 )
[COMMAND] and change the setting
according to the instructions of the
menu.
Press the <ENTER> button after selecting the
z
[COMMAND], and you can set detailed settings.
TIME
Set the time at which the command
will be executed using ▲▼ buttons.
COMMAND
Select a command to execute at the
set time from the following.
POWER ON
•
STANDBY
•
AV MUTE ON
•
AV MUTE OFF
•
INPUT
•
COMPUTER
INPUT VIDEO
•
INPUT S-VIDEO
•
INPUT DVI-I
•
INPUT HDMI
•
INPUT
•
NETWORK
LAMP POWER
•
NORMAL
LAMP POWER
•
ECO
SIDE BY SIDE
•
MODE OFF*
1
SIDE BY SIDE
•
MODE ON*
1
IN STANDBY
•
MODE (AUDIO)
ON
IN STANDBY
•
MODE (AUDIO)
OFF
VOLUME
•
PT-FW430U only*1 :
Press ▲▼ to select [STORE] and 5 )
press the <ENTER> button.
Note
If you try to register a setting that would cause the lamp to
z
ash for a short time, an error message will be displayed on
the screen. Set the [TIME] and [COMMAND] again.
If multiple commands have been set for the same time,
z
they are executed in chronological order starting from the
smallest command number.
The setting time operates under the local time.
z
(
Æ
page 62)
If an operation is executed with the remote control or
z
control panel of the projector or with a control command
before the command set in the schedule is executed, the
command set with this function may not be executed.