Filter
Top Products
Technical Information
ENGLISH -
79
Appendix
J
Cable specications
[When connected to a computer]
Projector
1 NC NC 1
Computer (DTE
specications)
2 2
3 3
4 NC NC 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
J
Control commands
When controlling the projector from a computer, the following commands are available:
[Projector control command]
Command Control contents Remarks
PON Power [ON]
In stand-by mode, all commends other than [PON] are invalid.
During lamp ON operation, the [PON] command is not accepted.
POF Power [OFF]
If the [PON] command is sent while the cooling fan is operating after the lamp has been
switched off, the lamp ON operation will start 30 seconds after the lamp has turned off, in
order to protect the lamp.
AVL Volume
(Parameter)
000 (adjustment value 0) to 063 (adjustment value 63)
IIS INPUT selection
(Parameter)
VID = VIDEO
SVD = S –VIDEO
RG1 = COMPUTER
DVI = DVI-I
HD1 = HDMI
NWP = NETWORK
Q$S
Lamp condition
query
(Call back)
0 = Stand-by
1 = Lamp ON control active
2 = Lamp ON
3 = Lamp OFF control active
OSH AV MUTE function
Turning off the projection and sound temporarily.
Sending the command switches ON/OFF.
Do not switch ON/OFF in a short period of time.