Filter
Top Products
PROJECTOR SETUP menu
ENGLISH -
59
Settings
ECO MANAGEMENT
Can optimize lamp power and reduce the power
consumption according to the application.
Press ▲▼ to select [ECO 1 )
MANAGEMENT].
Press the <ENTER> button.2 )
The [ECO MANAGEMENT] screen is displayed.
z
Press ▲▼ to select the item and press 3 )
◄► to switch the setting.
J
AUTO POWER SAVE
[AMBIENT LIGHT DETECTION],
[SIGNAL DETECTION], and [AV MUTE DETECTION]
functions can be used.
Note
Not available when [LAMP POWER] is set to [ECO].
z
Select [AUTO POWER SAVE] in Step 3.1.
Press ◄► to switch ON (Enable) / OFF 2.
(Disable) of the [AUTO POWER SAVE]
setting.
The setting will change as follows each time the
z
button is pressed.
ON OFF
ON Enables AUTO POWER SAVE
OFF Disables AUTO POWER SAVE
Press ▲▼ to select [AUTO POWER 3.
SAVE] conditions.
AMBIENT LIGHT
DETECTION
Adjusts the lamp power according
to the ambient brightness.
SIGNAL
DETECTION
Drops the lamp power when no
signal is input.
AV MUTE
DETECTION
Drops the lamp power in the AV
Mute mode.
Press ◄►to switch ON (Enable) / OFF 4.
(Disable) of the selected condition.
The setting will change as follows each time the
z
button is pressed
ON OFF
ON Enables the setting
OFF Disables the setting
Note
In following cases, [LAMP POWER] does not drop
z
automatically.
When [LAMP POWER] is [ECO].
•
Immediately after the lamp is turned on or immediately
•
after setting [LAMP POWER]
When [ECO MANAGEMENT] is [OFF], you cannot set
z
[AMBIENT LIGHT DETECTION], [SIGNAL DETECTION],
and [AV MUTE DETECTION] linked.
The selection made here is reected to the indication of
z
set ECO level in the “Multi Projector Monitoring & Control
Software” installed from the supplied CD-ROM.
J
NO SIGNAL SHUT-OFF
If no signal is input within a preset time, the projector
power is automatically switched to the standby state.
DISABLE 15 MIN 60 MIN
DISABLE
Disables NO SIGNAL SHUT-
OFF
15 MIN. - 60 MIN.
Allows you to set a time in 5
minute increments after which
the projector will automatically
shut down if there is no signal
Note
The selection made here is reected to the indication of
z
set ECO level in the “Multi Projector Monitoring & Control
Software” installed from the supplied CD-ROM.
The duration is set to 30 minutes under factory default
z
settings and after you perform [INITIALIZE ALL].
J
STANDBY MODE
This function can set the electric power when the
projector is standing by.
NORMAL ECO
NORMAL
Does not restrict functionality even in
standby mode
ECO
Restricts some functions in standby
mode to reduce power consumption
Note
If STANDBY MODE is set to [ECO], you cannot use
z
network functions when the projector is standing by. Also,
you cannot use some RS-232C protocol commands.
When you turn the POWER switch [ON], display of
the initial image may be delayed for approximately
10 seconds when compared with [NORMAL] mode
operation.
If set to [NORMAL], you can use network functions when
z
the projector is standing by.