Filter
Top Products
22
BIf there are any obstacles in between
the remote control unit and the
receivers, the remote control unit may
not operate correctly.
B
If strong light is allowed to shine onto
the remote control signal receiver,
correct remote control operation may
not be possible. Place the projector as
far away from light sources as possible.
BIf facing the remote control unit
toward the screen to operate the
projector, the operating range of the
remote control unit will be limited by
the amount of light reflection loss
caused by the characteristics of the
screen used.
NOTE:
BIf there are any obstacles in between
the remote control unit and the
receivers, the remote control unit may
not operate correctly.
B
If strong light is allowed to shine onto
the remote control signal receiver,
correct remote control operation may
not be possible. Place the projector as
far away from light sources as possible.
BIf facing the remote control unit
toward the screen to operate the
projector, the operating range of the
remote control unit will be limited by
the amount of light reflection loss
caused by the characteristics of the
screen used.
BDo not drop the remote control unit.
BKeep the remote control unit away from liquids.
BRemove the batteries if not using the remote control unit for long periods.
BDo not use rechargeable batteries.
NOTE:
BDo not drop the remote control unit.
BKeep the remote control unit away from liquids.
BRemove the batteries if not using the remote control unit for long periods.
BDo not use rechargeable batteries.
Operating range
If the remote control unit is held so
that it is facing directly in front of the
remote control signal receptors on
the front or rear of the projector, the
operating range is within
approximately 7 m (23´) from the
surfaces of the receptors.
Furthermore, the remote control unit
can be operated from an angle of
±30° to the left or right and ±15°
above or below the receptors.
#Open the cover.
AAA batteries
(two)
$Insert the batteries so that the
polarities are correct, and then close the
cover.
Inserting the batteries