Filter
Top Products
31
Basic Operation
RGBVIDEOAUTO SETUP
ON(G)
STANDBY(R)
ENTER
MENU
POWER SHUTTER
INPUT
TEMP
LAMPRGB INPUT
– FOCUS +
–
ZOOM +
*
Press the FOCUS +/- or ZOOM
+/- buttons to adjust the
projected image focus and size.
The projected image focus can
also be adjusted by turning the
focus ring. To make fine
adjustments to the projected
image focus, use the FOCUS +/-
buttons.
Focus
Turning off the power
#Press the POWER button. “Power
OFF” is displayed on the screen.
$Select “OK” using the
II
and
HH
buttons and press the ENTER button.
The lamp unit will switch off and the picture will stop being projected. (The
power indicator on the projector will illuminate orange.)
%Wait until the power indicator on the projector illuminates red (until
the cooling fan stops).
Do not in any way cut power to the projector while the cooling fan is still
operating. Be careful not to switch off the MAIN POWER switch of the
projector, unplug the power cord from the electrical outlet or turn off in-line
switches such as tabletop power switches.
&Press the MAIN POWER switch to the “O” side to turn off the power.
NOTE:
BAfter the power is turned off, the lamp unit will take some time to cool
down. If you turn the power back on again before the lamp unit has cooled
down, the lamp unit may not turn on straight away, but it will turn on
automatically after a short period. (During this time, the power indicator on
the projector will flash orange.)
BWhen the projector is in standby mode (the power indicator on the
projector is illuminated red), the projector will still draw a maximum 3.5 W
of power, even when the cooling fan has stopped.
BIf the MAIN POWER switch is accidentally turned off while the projector is
being used, the lamp unit may not turn on straight away after the power is
turned back on. In such cases, the lamp unit will turn back on
automatically after a short period. (During this time, the power indicator on
the projector will flash green.)
BA tinkling sound may be heard while the power indicator is turned off, but
this is not a sign of a malfunction.
BYou can also turn off the power by pressing the POWER button twice.
BWhen the WEB STANDBY is set to “ON”, the cooling fan operates and
the power indicator on the projector flashes slowly in red and the projector
draw a maximum 43 W of power. (page 47) (PT-L780NTU only)
Power OFF
OK CANCEL