Panasonic TQBH9003-6 Projector User Manual


 
55
Advanced Operation
Putting the power cord and
remote control unit away
#Put the remote control unit
into the cable cover with the
buttons facing downward to
prevent them from being
pressed.
$Put the power cords and
other cords into the cable
cover.
%Put the Velcro through the
hole, and tape it to prevent
the cords from dropping out.
&Insert the hook 1 of the cable
cover into the mounting hole
in the projector.
'Push in the hook 2 until it
locks into place.
(Tighten the screw by turning it
clockwise.
#Loosen the screw by turning it
anticlockwise.
$Release the two hooks at the
top of the cable cover.
%Pull the cable cover to the
rear to remove it from the
projector.
Removing the cable cover
Installing the cable cover
#
$
%
Hook1
Hook2
Velcro
Remote control unit
(Infrared emitter)
#
%
˛$
˛$
˛'
&
(
˛'
NOTE:
Do not lift up the projector by holding the cable, otherwise the cable
cover might come off.