Filter
Top Products
Customizing Your Machine
38
Fax Parameter Table
34 ENERGY SAVER
MODE
1 OFF To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
(1 to 120 minutes) for the machine to enter into the
selected mode.
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
OFF : The unit will remain in standby mode
and consume more energy than when
in Energy-Saver or Sleep modes.
ENERGY-SAVER: Saves energy by consuming less
power than when in standby mode by
turning off the fuser unit after the
specified time.
SLEEP : This is the lowest power state that the
machine enters after the specified time
without actually turning off.
2 ENERGY-
SAVER
3 SLEEP
35 DAYLIGHT TIME 1 OFF Set the Daylight Time according to your local regulation.
OFF : Daylight time is not applied.
MAR 2nd : From 2:00 AM on the 2nd Sunday in March to
2:00 AM on the 1st Sunday in November.
APR 1st : From 2:00 AM on the 1st Sunday in April to
2:00 AM on the Last Sunday in October.
2MAR 2nd
3 APR 1st
36 RING PATTERN
(DRD)
1 INVALID Selecting whether or not the machine is available for "DRD
Service". If this parameter is set to "VALID", your machine
detects the specified ring pattern only when receiving a
document automatically.
2VALID
37 RCV TO MEMORY (----) Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to ON, this parameter will not be shown
on the LCD display. (See page 96)
38 ACCESS CODE (----) Enter a 4-digit Access Code to secure the machine from
unauthorized use. (See page 94)
39 PIN CODE ACCESS 1 NONE Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code. (See page 106)
2SUFFIX
3PREFIX
42 CONF. FILE SAVE 1 INVALID Selecting whether the machine saves the confidential
polled file even after the file is polled once.
2VALID
43 PASSWORD-XMT 1 OFF Setting a 4-digit XMT-Password and selecting whether the
machine performs and checks the XMT-Password of the
receiving station when transmitting. (See page 111)
2ON
44 PASSWORD-RCV 1 OFF Setting a 4-digit RCV-Password and selecting whether the
machine performs and checks the RCV-Password of the
transmitting station when receiving. (See page 112)
2ON
46 SELECT RCV 1 INVALID Selecting whether the machine performs selective
reception. (See page 109)
2VALID
47 REMOTE RCV 1 INVALID Selecting whether or not the machine accepts remote
reception command. (See page 67)
2VALID
48 TELEPHONE LINE 1 PSTN Selecting the type of line connected.
2PBX
49 PSTN ACCESS CODE (----) Setting PSTN Access Code. (Up to 4 digits)
No. Parameter
Setting
Number
Setting Comments
UF6200_FAX_USA_PJQMC1259ZA.book 38 ページ ２００８年８月１９日 火曜日 午後３時１２分