Filter
Top Products
Hotwire Menus and Screens
2-12
8000-A2-GB20-50
April 2000
The status of each DSL card is indicated by codes being displayed in any of eight
positions to the right of the card selected.
NOTE:
If an option is not active, an underscore is shown in its place.
Column
Heading
Position Display Description
Slt <slot number> M = MCC, MCP or MCC Plus card
1–18 = slot number for DSL card
Mdl # <card type> First four digits of the card model number:
8540 = 8540 RADSL card
8546 = 8546 RADSL card
8000 = MCC/MCP/MCC Plus card
Stat
1 T or _ Test mode. Card currently in test mode or _ for
no active test.
2 M or _ Major alarm. Major alarm present on card or _
for no active major alarm.
3 R or _ Minor alarm. Minor alarm present on card or _
for no minor alarm active.
Eth 4 U, D, or X Status of Ethernet link:
U=Up, D=Down, X=Disabled
8546
(DSL
card)
5 and up U, D, X, or H Status of DSL card Port 1–4 link:
U=Up, D=Down, X=Disabled, or
H=Handshaking
WAN Lnk For M/SDSL and M/HDSL cards.
For example, if you select DSL card in Slot 4, the following may be displayed:
4: 8546 _MRD UXXX
Position: 1234 5678
This display shows the following:
H There is an 8546 card in Slot 4
H Position 1 – no current test (_)
H Position 2 – major alarm is present (M)
H Position 3 – minor alarm is present (R)
H Position 4 – Ethernet link is down (D)
H Position 5 – DSL port 1 is up (U)
H Positions 6, 7 and 8 – DSL ports 2, 3 and 4 are disabled (X)
On the Card Selection screen, there is a prompt used to select a specific card in
the DSL chassis. When a DSL slot number is entered, you are connected to the
DSL card you selected.
For more information about the status displayed on this screen, such as major
and minor alarms, see Troubleshooting in Chapter 5, Diagnostics and
Troubleshooting.