Filter
Top Products
C. Router CLI Commands, Codes, and Designations
9128-A2-GB20-80 September 2002
C-25
Show Commands
Show commands allow you to display information.
Table C-13. Show Commands (1 of 4)
show
arp
Minimum Access Level:
Operator
Command Mode:
Standard
Displays the devices in the ARP table.
The general format of the
show arp
command is:
The first column displays the IP address. The second column displays the actual time left
for the specific entry, or “STATIC” for configured static entries. The third column displays
the MAC address for the ARP entry. The fourth column displays the ARP type (only ARPA
is currently supported). The fifth column displays the Interface or sub-interface for the
ARP table entry.
show
bridge
Minimum Access Level:
Operator
Command Mode:
Standard
Displays entries in the bridge forwarding database.
show
configuration
Minimum Access Level:
Operator
Command Mode:
Standard
Displays/outputs a sequence of commands in the form of ASCII strings that have the
effect of setting all configurable parameters to the current values in memory.
Passwords are write-only and not output. The text file can be used with a terminal
emulation program. Refer to
Configuring the Router Using Terminal Emulation
in
Chapter 5,
Configuring the FrameSaver SLV Router.
The general format of the
show config
command is:
global commands
!
interface n
interface n commands....
!
interface n sub-interface n
interface n sub-interface n commands...
!
interface n sub-interface n+1
interface n sub-interface n+1 commands...
interface n+1
IP Address Timeout (min) MAC address Type Interface
x.x.x.x
STATIC
xx:xx:xx:xx:xx:xx
ARPA
x.x.x.x time xx:xx:xx:xx:xx:xx
ARPA
Interface